Cut your tires in half, and save time and money with easy transportation and legal disposal.

ERIT 9100 Series Tire Cutter Features: COMPACT- Only 5 sq. ft of floor space required. EASY foot petal operation FAST, as many as 4 tires per minute! ERGONOMIC OPERATION- Lift tire only 10"-12" to cut! INDUSTRIAL-DUTY- Designed for continuous everyday use! LONG-LASTING- Cutting Blade warranted for 5,000 tires! QUICK & EASY blade changing! SIMPLE DESIGN with fewer moving parts!

Operates on shop air pressure and 240 vac or 115 vac.
Place tire on horn and depress foot actuator. Tire is moved up into the cutter and the cutter motor automatically turns on. When the foot actuator is released the horn lowers and the cutter motor stops.
Compact. Occupies a limited floor space.
Designed for industrial/heavy duty use.

Tool steel blade for long wear, 5,000 or more tires.
Blade is interchangeable in minutes.
Cutting tires in half allows for easier transportation and disposal.
Optional four digit display keeps count of the tires you cut.
Cuts 13" Thru 16.5" Tires

Cutting tires on the circumference has a practical value. Most state laws allow a tire cut in this way to be put in a landfill. National legislation is on its way which may allow the same. It is an option of the local landfill to accept tires in this form. It is also economical to transport cut tires since they occupy 1/2 to 1/3 the space of uncut tires. We guarantee the blade to last 5000 cuts. Futures blades are interchangeable in minutes. We are confident ERIT will not only pay for itself, but make you money.

How does it work?

An uncut tire is set in place ready to be cut. The operator then depressed the foot valve. An air cylinder inside ERIT moves the tire up into the cutting knife. Just when the knife meets the tire the motor turns on automatically, and the cutting begins. At the end of the cut, the operator releases the foot valve, the horn lowers, and the two tire halves are discarded.

How much space is required?

Notice the compact design. The ERIT can be placed along a wall and occupy a space of only 32 inches wide by 22 inches deep by 63 inches high. A power cord is supplied, however, the machine should have its own dedicated circuit to assure full voltage and power. There is a 1/4 IPS thread near the bottom so your air line fitting can be used to supply air pressure.

Two 235/86 R16, ten ply tires cut in half and stacked together. Total cutting time for both tires, less than one minute. Tires cut in half occupy less than half the space as uncut tires and when stacked with the cut edge down, do not accumulate water either.

Call our Tire Disposal Division at (800) 486-1223!

Contacting Us | INFO Request Form

Send mail to Company Webmaster with questions or comments about our site.
Copyright © 2006 Glen Martin Engineering, Inc.
Last modified:  02/18/04